The edge protection design of anti-slip steel walk boards follows construction safety norms,aiming to prevent edge deformation,burr scratches and accidental slipping,with no enterprise-related information involved.First,edge reinforcement:the board edges are folded and pressed to form a 10-15mm thick reinforced edge,enhancing structural strength and avoiding edge warping or cracking under stress.Second,anti-collision protection:the four corners of the board are processed into rounded corners(radius 5-8mm)to eliminate sharp edges,reducing collision damage and operator scratches.Third,anti-slip extension:the anti-slip structure(serrations or raised dots)extends to the edge of the board,ensuring no slippery dead corners at the edge.Fourth,burr removal:all edge cuts are polished smoothly to remove burrs and sharp edges,preventing damage to the anti-corrosion coating and operator injury.In addition,for hook-type walk boards,the edge near the hook is reinforced with extra steel plates to avoid edge deformation affecting hook connection stability;for extra-long walk boards,edge reinforcing ribs are added every 1.5m to enhance edge load-bearing capacity.All edge protection designs comply with construction component safety standards,ensuring the walk board edges remain intact during installation,use and transportation.
References
GB/T 7714 Format
[1]Anonymous.Edge Protection Design Standards for Anti-slip Steel Walk Boards[n.d.].
[2]Anonymous.Safety Design Norms for Steel Walk Board Edges[n.d.].
[3]Anonymous.Edge Reinforcement and Anti-collision Requirements for Construction Steel Planks[n.d.].
MLA Format
Anonymous."Edge Protection Design Standards for Anti-slip Steel Walk Boards."n.d.
Anonymous."Safety Design Norms for Steel Walk Board Edges."n.d.
Anonymous."Edge Reinforcement and Anti-collision Requirements for Construction Steel Planks."n.d.
APA Format
Anonymous.(n.d.).Edge protection design standards for anti-slip steel walk boards.
Anonymous.(n.d.).Safety design norms for steel walk board edges.
Anonymous.(n.d.).Edge reinforcement and anti-collision requirements for construction steel planks.